Pengaruh kecepatan udara dan massa gabah terhadap kecepatan pengeringan gabah menggunakan pengering terfluidisasi

S. Syahrul, M. Mirmanto, S. Romdani, S. Sukmawaty

Abstract


Grain processing does not meet the actual grain harvests. This is due to the unsuitable drying process. Milling grain entrepreneurs and farmers in Indonesia are currently conducting a drying process under the sun. Based on the National Standards Body (BSN), grain moisture content must be at 14% to maintain the grain at high qualities. The purpose of this study is to determine the effect of velocity and grain mass variations on drying times. The grain used in this study contains an initial moisture content of 22% ± 0.5%. The grain is dried by inserting it into the drying chamber and varying the air velocities and grain mass. The air velocities used are 4 m/s, 5 m/s, 6 m/s and the variations of the grain mass are 1 kg 2 kg and 3 kg. The results show that increasing the air velocity decreases the drying time. On the other hand, when the grain mass is increased, the drying time elevates. The air velocity and mass of the grain that results in the fastest drying time are 6 m/s and 2 kg. The time required for achieving the water content of 13.6% is 30 menit. At the air velocity of 4 m/s, and the grain masses of 1 kg, 2 kg, and 3 kg, to achieve moisture contents of 13.4%, 13.5% and 13.4% the drying time needs 50 minutes.

Full Text:

PDF

References


BSN, 1987, Gabah standar mutu, Badan Standar Nasional, Jakarta.

Herawan D., 1992, Uji percontohan (pilot testing) pengering cabe merah (capsicum annuum L) tipe konveksi bebas untuk pengusaha tingkat pedesaan, Skripsi, FTP, IPB, Bogor.

Hidayati N., Diah U.P., Ratnawati, Suherman, 2013, Penerapan teknologi fluidized bed drayer dengan penambahan zeolit 3a untuk meningkatkan efesiensi pengering gabah, Jurnal Teknologi Kimia dan Industri, Vol. 2, No.4, 65-71.

Holman J.P.,1994, Perpindahan kalor, Erlangga, Jakarta.

Incropera F P., Dewit D.P., Bergman T.L., Lavine A.S., 2006, Fundamental of Heat and Mass Transfer, Sixth Editions, John Wiley and Sons,USA

Indriani I., Novi N.H., Sarosa A.H., Aini H.N., 2009, Pembuatan fluidized bed dryer untuk pengeringan benih pertanian secara semi batch, Jurusan Teknik Kimia, Fakultas Teknik, Universitas Sebelas Maret, Surakarta.

Mirmanto, Sulistyowati E.D., Okariawan IDK., Effect of radiator position and mass flux on the dryer room heat transfer rate, Results in Physics, Vol. 6, 139-144.

Mirmanto, Sulistyowati E.D., Okariawan IDK., Effect of inlet temperature and ventilation on heat transfer rate and water content removal of red chilies, Journal of Mechanical Science and Tecknology, Vol. 31, No. 3, 1531-1537.

Mulyono D., Runanda J.C., 2013, Pengering gabah menggunakan zeolit 3a pada alat ungun terfluidisasi, Jurnal Teknik Kimia dan Industri, Vol. 2, No. 2, 40-45.

Taufiq M., 2004, Pengaruh temperatur terhadap laju pengeringan jagung pada pengering konvensional dan fluidized bed, Fakultas Teknik Universitas Sebelas Maret, Surakarta.

Widjanarko A., Ridwan M., Djaini M., Ratnawati, 2012, Penggunaan zeolit sintetis dalam pengeringan gabah dengan proses fluidisasi indirect contact, Jurnal Teknologi Kimia dan Industri , Vol, 2, No. 2, 103-110.

Yahya M., 2015, Kajian karakteristik pengering fluidisasi terintegrasi dengan tungku biomassa untuk pengeringan padi, Jurnal Teknik Mesin, Vol. 5, No. 2, 65-71.




DOI: https://doi.org/10.29303/dtm.v7i1.8

Refbacks

  • There are currently no refbacks.


Copyright (c) 2017 Dinamika Teknik Mesin

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

 
After being re-accredited, the Journal of Dinamika Teknik Mesin, still has sinta 3 (S3) which is valid until 2025.
View My Stats