KEAUSAN BANTALAN BOLA YANG DI IMPLANTASI ION TiN DENGAN PELUMASAN GREASE

S. Sinarep

Abstract


It has been conducted on the effect of ion implantation of TiN to wear ball bearings with grease lubrication. Ball bearing is one of the supporting components contained in the machine and the parts of a rotating element as found in automotive components. During the operation, this component causes the surface wear and vibration caused by continuous movement during loading. Ion implanted TiN ball bearing at the time of 90 minutes, the energy of 100 keV and current 10 μA are ring inside the outer ring, and ball as the wear test samples. Tests carried out with 3 variations of wear load and 3100 rpm shaft rotation. Grease is used to mark the torch. Then 3.9 grams of grease in then applied to the outer ring, inner ring and the ball. The test results showed that the wear volume increased with increasing the load on ball bearing non-implantation with grease lubrication, while the ion implanted TiN almost no increase. Wear resistance increased in metal ion implanted TiN. It is characterized by decreasing in wear rate when compared with non-metal implants. And traces of scratches experienced a very significant reduction in metal ion implanted TiN.


Full Text:

PDF

References


Hutchings, I.M., 1992, “Tribology Friction and Wear of Engineering Materials”, London. Kenji, F., Koichiro, W., Kazuo, U. and Tadashi, S., 2004, “Preparation of Highly Adhesive Diamond-Like Carbon Films by Plasma CVD Combined With Ion Implantation”, IHI Engineering Review, Vol. 37, No 1. Moller, W. and Mukherjee, S., 2002, “PlasmaBased Ion Implantation”, Current Science, Vol. 83, No. 3. Mudjijana, Sujatmoko, Suyitno, dan Susanto, 2001, “Deposition Lapisan Tipis Tintanium Nitrida pada Subtrat Aluminium dengan Teknik Sputtering DC”, Proseding Seminar Nasional Pengembangan Keramik Teknologi dan Aplikasinya, Serpong, Indonesia. NSK, 2003, “Rolling Motion & Rolling Element”, NSK Co. Ltd. Singapore. Rizal, M. dan Bendiyasa, I.M., 2004, “Forum Teknik”. Ryssel, Heiner, Rugi, and Ingolg, 1986, “Ion Implantation”, John Willey and Sons. New York. Soekrisno, 2004, “Perbandingan Kekerasan Struktur Mikro dan Komposisi kimia Bantalan Bola Produk Jepang dan China”, Jurnal Mesin dan Industri, Vol. 1, No. 3, Hal. 9-14. Yao, S.H., Kao, W.H., Su, Y.L., Liu, T.H., 2004, “Effect of Periods on Wear Performance of TiN/AlN Superlattice Flims”, Material Science and Engineering A 392, pp, 380-385. Zeng, Z.M., Tian, X.B. and Chu, P.K., 2003, “Ion Enhanced Deposition by Dual Titanium and Acetylene Plasma Immersion Ion Implantation”, Journal Vacum Science Tecnology, A 21.


Refbacks

  • There are currently no refbacks.


Copyright (c) 2017 Dinamika Teknik Mesin

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

 
After being re-accredited, the Journal of Dinamika Teknik Mesin, still has sinta 3 (S3) which is valid until 2025.
View My Stats